Too many errors or circuit board replaced
Breakdown: the boiler is stopped
The circuit board has logged too many errors, for example because of a blocked flue or condensate trap, a low gas pressure or flue gas being drawn back in, or it has just been replaced. The boiler locks out for safety; for this code our technician puts it back into service, after finding the cause.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Do not reset the boiler: call us.
Does your boiler show A98?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code A98
The meaning depends on the boiler: find yours below.
Too many SW errors or error caused by replacing the board
What our technician checks
- After a board replacement: resetting the fault and the calibration (full manual or AUTO SETUP)
- The cause first (flue, condensate trap, gas, combustion), then the reset and a correct ignition
- The circuit board, replaced if needed