Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Ferroli Fault code Ferroli
A56

Calibration failed or not completed

Breakdown: the boiler is stopped

On a Bluehelix Top RRT K 50, the calibration the boiler runs by itself to set its combustion has failed or could not finish: wrong parameters, electrode badly placed or disconnected, flue gases recirculating inside the boiler, or too little water circulation or heat drawn off during the calibration. The boiler locks out and only starts again after a reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show A56?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code A56

The meaning depends on the boiler: find yours below.

A56

Calibration fault / Calibration procedure not completed

Breakdown: the boiler is stopped Bluehelix Top RRT K 50

What our technician checks

  • The parameters, then a 100% calibration
  • The electrode position, replaced if needed, then a new 100% calibration
  • The tightness of the flue duct and of the seals
  • A new calibration with a hot water tap open, until the flame stops flashing (about 2 minutes)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.