Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Elco Fault code Elco
731

Buffer tank top temperature too high

Breakdown: the boiler is stopped

On a Thision L Plus or Trigon L Plus, the sensor at the top of the buffer tank reads a temperature that is too high. This is a locking fault: it stays on the display until a reset, and if it comes back our technician has to find the cause.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 731?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code 731

The meaning depends on the boiler: find yours below.

731

Buffer High Probe Overtemperature

Breakdown: the boiler is stopped Thision L Plus, Trigon L Plus

What our technician checks

  • The temperature read by the top sensor (diagnostics 20.1.2)
  • The buffer tank set points (menu 20.0)
  • The buffer tank top sensor, its input on the boiler and its wiring
  • Its resistance, measured with the boiler switched off and compared with the resistance table (NTC 10k)
  • The buffer charging pump and the output that drives it

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.