Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Elco Fault code Elco
101

Overheat on a burner

Breakdown: the boiler is stopped

On a Thision L Plus or Trigon L Plus, the boiler has detected overheating on burner 1 or 2 (the figure shown after the code) and has stopped it. This is a locking fault: the burner stays off until a reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 101?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code 101

The small number shown beside the code tells which.

101
1

Overheat

Breakdown: the boiler is stopped Thision L Plus, Trigon L Plus
101
2

Overheat

Breakdown: the boiler is stopped Thision L Plus, Trigon L Plus

What our technician checks

  • The circulating pump: operation, noise, damage and leaks
  • The flow rate and modulation of the pump of the burner concerned (diagnostics 24.10 or 24.11)
  • The flow and return temperatures of the burner concerned (diagnostics 24.10 or 24.11)
  • The set temperature and the actual flow temperature
  • The system pressure (plausibility check)
  • The flow and return sensors, measured with the boiler switched off and compared with the resistance table (NTC 10k)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.