Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Elco Fault code Elco
5P1

No flame (warning 1)

Blocking: it retries by itself

On a Thision L Plus or Trigon L Plus, burner 1 or 2 (the figure shown after the code) has not detected a flame during an ignition attempt (display: No Flame 1). This is a warning: the boiler tries again by itself, but if ignition fails again, it locks the burner out (code 501).

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show 5P1?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code 5P1

The small number shown beside the code tells which.

5P1
1

No Flame 1

Blocking: it retries by itself Thision L Plus, Trigon L Plus
5P1
2

No Flame 1

Blocking: it retries by itself Thision L Plus, Trigon L Plus

What our technician checks

  • The ignition electrode: condition, wear, resistance of 100 Ω at most
  • The detection electrode: ionisation current of at least 4 μA at full load
  • The electrode cable and its fuse, if the electrode is damaged
  • The static and dynamic gas pressure
  • The gas valve and the venturi: damage, corrosion and operation
  • The siphon, its dirt trap and the condensate drain

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.