Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Elco Fault code Elco
218

Pressure monitoring triggered

Blocking: it retries by itself

On a Straton XL, the controller reports a fault from its pressure monitoring. It is a technical fault shown on the display: check the water pressure, then have our technician check the system if the fault stays.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Look at the boiler's pressure gauge: the needle must be in the green zone. If the pressure is too low, top up with water (filling and drain tap).
  3. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show 218?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code 218

The meaning depends on the boiler: find yours below.

218

Pressure monitoring

Blocking: it retries by itself Straton XL

What our technician checks

  • The system water pressure
  • The control and safety devices, including the low-water safety
  • Inputs H1, H2 and H3 set to pressure measurement and their sensors

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.