Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Elco Fault code Elco
163

Boiler parameter setup failed

Breakdown: the boiler is stopped

On a Thision L Plus or Trigon L Plus, the controller reports that the boiler's basic parameter setup is not valid (display: Boiler parametrization KO). This is a locking fault: it stays on the display until a reset, and if it comes back our technician has to find the cause.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 163?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code 163

The meaning depends on the boiler: find yours below.

163

Boiler parametrization KO

Breakdown: the boiler is stopped Thision L Plus, Trigon L Plus

What our technician checks

  • The boiler type set in the controller (parameter 24.0.9)
  • The connection of the boiler sensors (NTC), which the parameter setup waits for (message 164)
  • The parameter backup and restore functions (24.9.2 and 24.9.3)
  • The boiler control unit (circuit board)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.