Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Elco Fault code Elco
130

Flue gas temperature too high

Breakdown: the boiler is stopped

The boiler's flue gases went above their maximum temperature (90 °C on a Trigon XL) and the burner cut out for safety. Do not reset the boiler: our technician must first find out why the flue gases are too hot.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Do not reset the boiler: call us.

Does your boiler show 130?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code 130

The meaning depends on the boiler: find yours below.

130

Flue gas temperature max. limit exceeded

Breakdown: the boiler is stopped Trigon XL
130

Flue gas temperature limit exceeded

Breakdown: the boiler is stopped Thision S Plus, Trigon S Plus, Trigon XXL

What our technician checks

  • The flue gas sensor and its reading (NTC 10 kΩ on a Trigon XXL)
  • The combustion chamber and the heat exchanger, cleaned if needed
  • The combustion values at full and minimum load
  • The water flow through the boiler

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.