Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Bulex Fault code Bulex
S.30

Heating blocked by the room thermostat

Information: nothing to do

The room thermostat connected to the boiler is not asking for heat: heating stays blocked until its next demand (on a Thema Condens F or an Isotwin Condens F, the boiler is simply on standby, with no heating or hot water demand). This is a normal operating message: there is nothing to do.

Nothing to do

This message belongs to the boiler's normal operation.

Call us

The variants of code S.30

The meaning depends on the boiler: find yours below.

S.030

There is no demand from the thermostat. Heating mode is blocked

Information: nothing to do Isotwin Condens CS/1, Thema Condens CS/1
S.30

Heating mode blocked by the room thermostat

Information: nothing to do Isotwin Condens, Thema Condens
S.30

Default state, no heating demand, no domestic hot water demand

Information: nothing to do Isotwin Condens F, Thema Condens F
S.30

The room thermostat is blocking heating mode (terminal 3-4 open)

Information: nothing to do Thema Condens F AS 45/65
S.30

Heating mode blocked by room thermostat

Information: nothing to do Thema Condens AS 48/65, Thema Condens F AS 80, ThemaClassic C30, Thematek C 18/24-LC/1, Thematek C25, Thermomaster
S.30

No start following a start request from the external controller

Information: nothing to do Thermomaster F

The boilers that show this code

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.