Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Bulex Fault code Bulex
S.20

Hot water demand: cylinder or keep-warm

Information: nothing to do

On most boilers, S.20 means that a hot water demand is under way (hot water cylinder or keep-warm); on a Thema Condens F or an Isotwin Condens F, the pump starts before the burner. On the CS/1 models (code S.020), the same number means the opposite, that there is no cylinder charging demand; in both cases this is a normal operating message: there is nothing to do.

Nothing to do

This message belongs to the boiler's normal operation.

Call us

The variants of code S.20

The meaning depends on the boiler: find yours below.

S.020

There is no domestic hot water cylinder charging demand

Information: nothing to do Isotwin Condens CS/1, Thema Condens CS/1
S.20

Domestic hot water demand is active

Information: nothing to do Isotwin Condens, Thema Condens
S.20

Pump pre-run

Information: nothing to do Isotwin Condens F, Thema Condens F
S.20

Hot water demand

Information: nothing to do Thema Condens F AS 45/65
S.20

Domestic hot water demand

Information: nothing to do Thema Condens AS 48/65, Thema Condens F AS 80, ThemaClassic C30, Thematek C25
S.20

Domestic hot water mode: demand

Information: nothing to do Thermomaster
S.20

Domestic hot water production / pump started

Information: nothing to do Thermomaster F
S.20

Cylinder mode: domestic hot water demand

Information: nothing to do Thematek C 18/24-LC/1

The boilers that show this code

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.