Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
H06

Flame often lost at startup

Blocking: it retries by itself

During the last burner starts, the flame often went out. The manufacturer lists as possible causes the ignition, the setting or parts of the burner, or a blocked flue gas and air path.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show H06?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code H06

The small number shown beside the code tells which.

H06
1016

Frequent flame loss

Blocking: it retries by itself GB212, KB192i, KB192i.2

The boilers that show this code

What our technician checks

  • The blocking fault memory, to see in which phase the flame goes out
  • The gas supply and the gas supply equipment
  • The air intake and flue gas outlet openings, and their path: cleared
  • The flame sensor current, read on the control module
  • The ignition, using the relay test of the control module
  • The burner setting, according to its settings table
  • The solenoid valve

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.