Internal burner control unit fault
Breakdown: the boiler is stopped
The unit that controls the burner reports an internal fault; on the KB195i.2 (oil), the manual points to the flame sensor. The boiler locks out and will only restart after a reset.
What you can do
- Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show EE?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
Choose a real expert
Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.
The variants of code EE
The small number shown beside the code tells which.
Using the control unit, check in the service level under the Faults option whether this…
Internal fault
The boilers that show this code
What our technician checks
- A reset using the button on the burner control unit
- If the fault comes back often: contact with a Buderus service center, quoting the fault code
- KB195i.2: the flame sensor and its holder (dirt, position), replaced if necessary
- KB195i.2: the burner control unit, replaced if the fault comes back often or cannot be cleared