Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
A32

Circuit 2 flow sensor faulty

Blocking: it retries by itself

On a Logatherm or Bosch Compress heat pump (HMC300, HMC310 or HPC410 control), the flow temperature sensor of heating circuit 2 is faulty or badly connected, or the chosen configuration needs a flow sensor (number shown next to it: 3022). The system keeps running as far as possible; the controller puts this circuit into standby mode.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show A32?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code A32

The small number shown beside the code tells which.

A32
3022

Heating circuit 1… 4 flow temperature sensor faulty, standby mode active

Blocking: it retries by itself HMC300, HMC310, HPC410

What our technician checks

  • The circuit configuration, which needs a flow sensor
  • The cable between the heating circuit module and the flow sensor
  • The flow sensor, checked against the table, replaced if the values differ
  • The voltage at the sensor terminals on the heating circuit module, and the module if it does not match

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.