Flow temperature sensor faulty
Breakdown: the boiler is stopped
The flow temperature sensor, which measures the water sent to the heating, is faulty: the sensor or its cable is broken or short-circuited. On a Condens 7000iW the fault first shows as E2 350 or E2 351 and the boiler starts again by itself if it clears; if it persists it becomes E2 222 or E2 223 and, as on a Condens 3000 W, the boiler stops until it is reset.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Codes E2 350 or E2 351 on a Condens 7000iW: the boiler restarts by itself once the fault has cleared, do not reset it.
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show E2?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code E2
The small number shown beside the code tells which.
Flow NTC faulty
Flow temperature sensor faulty (short circuit)
Flow temperature sensor faulty (open circuit)
Flow temperature sensor faulty (short circuit)
Flow temperature sensor faulty (open circuit)
The boilers that show this code
What our technician checks
- The flow temperature sensor (NTC) and its cable (break, short circuit), replaced if needed