Heating water pressure problem
Blocking: it retries by itself
The boiler reports a water pressure problem in the heating circuit and blocks its burner. It is a blocking fault: the boiler starts again by itself, at most 150 seconds after the cause has gone.
What you can do
- Write down the code shown and the boiler model, without opening the appliance.
- Check the water pressure on the gauge, with the boiler cold: at least 1 bar. Too low? Switch the boiler off and top up a little at a time, as your installer showed you.
- Do you often have to top up? Call us.
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show b62?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code b62
The meaning depends on the boiler: find yours below.