Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
ACV Fault code ACV
b43

Memory parameters out of tolerance

Blocking: it retries by itself

On a Prestige MkII or a HeatMaster TC from before 2015 (MCBA controller), the value of the parameters stored in the controller's memory (EPROM) is out of tolerance. It is a blocking fault: the burner stays off and starts again by itself at most 150 seconds after the cause has gone.

What you can do

  1. Write down the code shown and the boiler model, without opening the appliance.
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show b43?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code b43

The meaning depends on the boiler: find yours below.

b43

EPROM parameter values out of tolerance

Blocking: it retries by itself MCBA

What our technician checks

  • The MCBA board, reprogrammed if the fault persists after two resets

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.