Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
ACV Fault code ACV
b26

Gas or water pressure switch open

Blocking: it retries by itself

On a Prestige MkII or a HeatMaster TC from before 2015 (MCBA controller), the burner is blocked because the gas pressure switch or the low water pressure switch is open (gas or water pressure too low, or a faulty switch); the controller manual also names an overheated pump control module and a pump that has stopped. It is a blocking fault: the burner stays off and starts again by itself at most 150 seconds after the cause has gone.

What you can do

  1. Write down the code shown and the boiler model, without opening the appliance.
  2. Check the water pressure on the gauge: at least 1 bar with the boiler cold. Too low? Switch the boiler off and top up in small amounts, as your installer showed you.
  3. Do you often have to top up? Call us.
  4. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show b26?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code b26

The meaning depends on the boiler: find yours below.

b26

Gas pressure switch or low water pressure switch open

Blocking: it retries by itself MCBA

What our technician checks

  • The gas pressure and the gas pressure switch
  • The water pressure and the low water pressure switch
  • The pump control module (overheating)
  • The pump: operation, flow and fouling

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.