Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Weishaupt Fault code Weishaupt
W20

Flame lost during ignition

Blocking: it retries by itself

On a WTC-GW or WTC-GB B series boiler, the flame goes out while the burner is lighting (safety time). It is a warning: the boiler does not lock out, but if the code comes back, our technician needs to check the gas supply and the burner.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show W20?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code W20

The meaning depends on the boiler: find yours below.

W20

Flame loss during the safety time

Blocking: it retries by itself WTC-GW/GB B (WEM)

What our technician checks

  • The gas supply pressure
  • The ionisation electrode, replaced if needed
  • The burner surface, cleaned or replaced, and clean combustion air
  • The flue, its tightness and clear passage, and the condensate drain
  • The start and ignition gas quantity settings (parameters 2.3.5 and 2.3.1), keeping the CO content in check
  • The flue gas shut-off device, replaced if needed
  • The gas valve unit, replaced if needed

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.