Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Weishaupt Fault code Weishaupt
F1

Extension module link or sensor T1

Breakdown: the boiler is stopped

On a WTC-GW or WTC-GB B series boiler, the meaning depends on the module showing the code: the heating circuit module no longer communicates, or sensor T1 is faulty (collector sensor on the solar module, sensor T1 on the cascade controller). It is a fault: the boiler locks out if safe operation is no longer guaranteed, and our technician has to fix the cause.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show F1?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F1

The meaning depends on the boiler: find yours below.

F1

Heating circuit EM: Heating circuit EM communication fault / Solar EM: Collector sensor (T1) faulty / Cascade controller: Sensor T1 fault

Breakdown: the boiler is stopped WTC-GW/GB B (WEM)

What our technician checks

  • The CAN bus link of the heating circuit module
  • Sensor T1 (solar collector or cascade) and its cable, replaced if needed

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.