Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Weishaupt Fault code Weishaupt
W17

Flow-return gap or combustion air too hot

Blocking: it retries by itself

On a WTC-GW or WTC-GB B series boiler and a WTC-GW C series boiler, the gap between the water going out to the heating and the water coming back is too large and the boiler has stopped for at least 3 minutes several times in a row; on a WTC-OB the combustion air drawn in by the burner is too hot. It is a warning that clears by itself, but a WTC-OB locks out (F17) after repeated warnings.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show W17?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code W17

The meaning depends on the boiler: find yours below.

W17

Temperature differential flow/return too large

Blocking: it retries by itself WTC-GW C (WEP), WTC-GW/GB B (WEM)
W17

Combustion air temperature too high (after several alarms, the system…

Blocking: it retries by itself WTC-OB (WCM-OB)

What our technician checks

  • The water flow through the boiler, increased if needed
  • The heat demand (heating curve), lowered if needed
  • The maximum heating output (parameter 2.1.2 on the B series, 3.1.2 on the C series)
  • The thermal insulation (WTC-OB)
  • The combustion air sensor, replaced if needed (WTC-OB)
  • The sensor wiring, in case two sensors are swapped (WTC-OB)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.