Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Weishaupt Fault code Weishaupt
F81

Remote control signal on N1 too high

Breakdown: the boiler is stopped

On a remotely controlled WTC-GW or WTC-GB B series boiler, the 0 to 10 V signal that an external controller sends to input N1 to set the flow temperature is too high. This is a fault: the boiler locks out if it can no longer run safely, and the display then offers to unlock it.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show F81?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F81

The meaning depends on the boiler: find yours below.

F81

Remote control signal (N1) too high

Breakdown: the boiler is stopped WTC-GW/GB B (WEM)

What our technician checks

  • The 0 to 10 V signal on input N1, connected with the right polarity
  • The voltage limits set for burner shutdown and fault reporting

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.