Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Weishaupt Fault code Weishaupt
F46

VPT multifunction sensor fault

Breakdown: the boiler is stopped

The VPT multifunction sensor, which measures flow, pressure and water temperatures in the boiler, reports a fault; this code exists on the WTC-GW and WTC-GB B series. The cause can be air in the system, too low a pressure or the sensor itself: the boiler locks out if it can no longer run safely, and our technician has to bleed the system or check the sensor.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show F46?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F46

The meaning depends on the boiler: find yours below.

F46

VPT multifunction sensor fault

Breakdown: the boiler is stopped WTC-GW/GB B (WEM)

What our technician checks

  • Bleeding the system (heating and hot water circuits)
  • Bleeding the boiler on the water side (automatic venting programme)
  • The system pressure, to be raised
  • An air separator to be fitted on the system
  • The VPT sensor and its connections, replaced if needed

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.