No water flow in the system
Breakdown: the boiler is stopped
The boiler detects no water flow in its circuit: closed valves, too little water or air, a blocked pump or fouling. The burner goes into fault and the internal pump stops: no heating and no hot water until a reset.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Check the system pressure: if it is below 1.0 bar, top up with water or call us.
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show F.75?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code F.75
The meaning depends on the boiler: find yours below.
No flow rate in the hydraulic circuit
What our technician checks
- The shut-off valves
- Filling to the required pressure and bleeding
- The flow sensor and its connection, replaced if needed
- The central circulation pump: operation and blockage
- Fouling of the heat exchanger, the non-return valves and the magnetite separators
- The expansion vessel pre-charge