Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Viessmann Fault code Viessmann
F.65

No flame when the burner starts

Breakdown: the boiler is stopped

When the burner starts, the boiler detects no flame, or a flame signal that is too weak: the cause is the gas supply or gas pressure, the gas valve, the ignition, the ionisation electrode or a build-up of condensate. The burner goes into fault: the boiler stops heating and only starts again after a reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Check that the boiler's gas supply valve is open.
  3. Reset the boiler once only.
  4. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show F.65?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F.65

The meaning depends on the boiler: find yours below.

F.65

No flame at burner start

Breakdown: the boiler is stopped Vitodens One Base

What our technician checks

  • The gas supply: gas pressure and gas flow monitor
  • The combined gas valve
  • Condensate build-up and the condensate drain (remove the fan unit before the burner)
  • The ionisation electrode and its connecting cable
  • The ignition electrode: cables to the ignition unit, gap to the burner grid and insulation
  • Fouling of the electrode and the burner grid

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.