Overheating during burner calibration
Breakdown: the boiler is stopped
During the automatic calibration of its combustion, the boiler could not get rid of enough heat and its monitoring thermostat tripped. The burner has locked out for safety and the boiler stops heating until it is reset.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show F.373?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code F.373
The meaning depends on the boiler: find yours below.
Overheating during ionisation current calibration
What our technician checks
- Enough heat being drawn off
- The circulation pump: fault, scale, blockage
- The 3-way diverter valve (relay test) and venting the system
- The flow rate sensor