Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Viessmann Fault code Viessmann
F.355

Abnormal flame signal at burner start

Breakdown: the boiler is stopped

When the burner starts, the boiler already sees a flame signal, for example because of built-up condensate, or its ignition transformer is not working properly. The burner has locked out for safety and the boiler stops heating until it is reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show F.355?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F.355

The meaning depends on the boiler: find yours below.

F.355

Analogue signal reference check

Breakdown: the boiler is stopped Vitodens One Base

What our technician checks

  • If condensate has built up: the insulation blocks, the electrodes and the burner gauze, replaced if needed
  • The burner control unit (BCU), to be replaced
  • The ignition transformer and ignition cable, replaced if needed
  • The fan unit, removed before opening the burner, and the electronics protected from water

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.