Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Remeha Fault code Remeha
83

Heat exchanger temperature too high

Breakdown: the boiler is stopped

The heat exchanger, where the water is heated, has become too hot, usually because the water is not flowing through it enough: pump not running, too little flow or water pressure too low. The boiler goes into lockout (the digits flash) and only restarts after a reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 83?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code 83

The meaning depends on the boiler: find yours below.

83

Heat exchanger temperature too high

Breakdown: the boiler is stopped Gas 210 Eco, Gas 310 Eco, Gas 610 Eco

What our technician checks

  • The circulation pump
  • The water flow through the boiler
  • The water pressure (above 0.8 bar)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.