Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Remeha Fault code Remeha
6

Control stop, temperature reached

Information: nothing to do

The water leaving for the heating is 5 °C above the requested temperature, so the burner stops for a while even though the heat demand continues. This is a normal control stop; on the Gas 210, 310 and 610 Eco it can also come from too large a difference between flow and return, or from the minimum time between two starts (Gas 210 Eco), and the boiler starts again by itself.

Nothing to do

This message belongs to the boiler's normal operation.

Call us

The variants of code 6

The meaning depends on the boiler: find yours below.

6

Flow temperature exceeds the programmed set point by 5°C

Information: nothing to do Quinta 25/30s 28/35c, Quinta 45/65
6

Flow temperature > 5°C above the programmed set point (heating)

Information: nothing to do Quinta 115, Quinta 85
6

Boiler stop (there is a heat demand but the boiler is not running

Information: nothing to do Gas 210 Eco
6

Control stop (burner off + post-purge)

Information: nothing to do Gas 310 Eco, Gas 610 Eco

The boilers that show this code

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.