Internal communication bus fault
Breakdown: the boiler is stopped
The boiler's electronic control has an internal communication fault, for example because of a damaged ribbon cable, moisture on the display or electromagnetic interference. The boiler goes into lockout (the digits flash) and only restarts after a reset.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show 11?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code 11
The meaning depends on the boiler: find yours below.
Problem with the internal communication bus
Problem with the internal communication bus or external influence
Internal bus fault or external influences
Problem with the internal communication bus (I2C bus) when reading the EPROM
The boilers that show this code
What our technician checks
- The ribbon cable in the control panel: damage or short circuit
- Moisture in the control panel and on the display
- External electromagnetic interference, to be removed, and the compliance of the electrical installation