Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Fault code Oertli
II■■■

Burner lockout: stray flame or light

Breakdown: the boiler is stopped

The burner box saw a flame or light when there should be none: a residual flame on a gas burner with a DMG box (II■■■), stray light or a faulty cell on an oil burner with a DKO 972, 976, 992 or 996 box (II■■■), a flame still present at the end of the pre-purge on a DKO 992 (■■■II). Followed by a long pause and long pulses (II■■■--■■■■■ on a DMG, II■■■--■■■■ on a DKO 976), the code instead means a manual or external lockout; in every case the burner stays off until it is reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show II■■■?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code II■■■

The meaning depends on the boiler: find yours below.

II■■■

Residual flame.

Breakdown: the boiler is stopped DMG 970 / 971 / 972 / 991
II■■■

Stray light during pre-purge

Breakdown: the boiler is stopped DKO 972, DKO 976, DKO 992
II■■■

Stray light

Breakdown: the boiler is stopped DKO 996
II■■■--■■■■

Manual or external lockout

Breakdown: the boiler is stopped DKO 976
II■■■--■■■■■

Manual or external lockout.

Breakdown: the boiler is stopped DMG 970 / 971 / 972 / 991
■■■II

Flame presence test

Breakdown: the boiler is stopped DKO 992

What our technician checks

  • The ionisation probe, its position and adjustment, replaced if faulty (DMG)
  • The flame detection cell and its leads, replaced if faulty (DKO)
  • The source of stray light reaching the cell during pre-purge (DKO)
  • The external fault that locked out the box (code with a long pause)
  • The control and safety box, replaced if it stays locked out after the first reset

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.