Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Mitsubishi Electric Fault code Mitsubishi Electric
LL

DIP switch setting error

Breakdown: the boiler is stopped

On an Ecodan heat pump (FTC4 to FTC7, F generation), LL means the small setting switches (DIP switches) on the FTC control board are set wrongly for operation with a boiler or for two-zone control. It is a fault that does not clear by itself: our technician clears the code (reset) once the cause has been found.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show LL?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code LL

The meaning depends on the boiler: find yours below.

LL

Setting errors of Dip switches on FTC4 control board

Breakdown: the boiler is stopped Ecodan FTC4
LL

Setting errors of DIP switches on FTC control board

Breakdown: the boiler is stopped Ecodan F generation, Ecodan FTC5, Ecodan FTC6, Ecodan FTC7

What our technician checks

  • For boiler operation: DIP switches SW1-1 and SW2-6 set to ON
  • For 2-zone control: DIP switches SW2-7 and SW2-6 set to ON

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.