Communication failure with the wireless remote controller
Breakdown: the boiler is stopped
On an Ecodan heat pump (FTC4 to FTC7, F generation), a code from J1 to J8 means the wireless receiver no longer communicates with the wireless remote controller (battery, pairing or radio link); on the F generation, J1 and J2 can also mean a communication failure between the bridge and a multiroom control device (thermostatic radiator valve, room thermostat). It is a fault that does not clear by itself: our technician clears the code (reset) once the cause has been found.
What you can do
- Write down the code shown and the heat pump model (on the rating plate).
- Check the wireless remote controller's battery and replace it if it is flat.
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show J1-J8?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code J1-J8
The meaning depends on the boiler: find yours below.
Communication failure between wireless receiver and wireless remote controller
What our technician checks
- The wireless remote controller's battery
- The pairing between the wireless receiver and the remote controller
- A test of the wireless communication (wireless system manual)
- On the F generation (J1, J2): the multiroom device battery and its pairing with the bridge