Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Mitsubishi Electric Fault code Mitsubishi Electric
L4

Hot water tank overheat protection

Breakdown: the boiler is stopped

On an Ecodan heat pump (FTC4 to FTC7, F generation), L4 means the overheat protection of the water in the domestic hot water tank has tripped; the manual points to the tank's immersion heater and its contactor. It is a fault that does not clear by itself: our technician clears the code (reset) once the cause has been found.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Is water running from a safety valve? Switch off the power to the heat pump and the immersion heater, then call us.
  3. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show L4?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code L4

The meaning depends on the boiler: find yours below.

L4

DHW tank water temperature overheat protection

Breakdown: the boiler is stopped Ecodan F generation, Ecodan FTC4, Ecodan FTC5, Ecodan FTC6, Ecodan FTC7

What our technician checks

  • The immersion heater of the hot water tank
  • The immersion heater contactor

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.