Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Mitsubishi Electric Fault code Mitsubishi Electric
LJ

Domestic hot water operation error

Breakdown: the boiler is stopped

On an Ecodan FTC5, FTC6 or FTC7 heat pump, LJ reports a domestic hot water operation error on systems whose hot water goes through an external plate heat exchanger, and on the F generation a domestic hot water operation error without that detail: disconnected tank sensor (thermistor THW5, or THW5B from FTC6 on), reduced flow or circulation pump. It is a fault that does not clear by itself: our technician clears the code (reset) once the cause has been found.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show LJ?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code LJ

The meaning depends on the boiler: find yours below.

LJ

DHW operation error (type of external plate HEX)

Breakdown: the boiler is stopped Ecodan FTC5, Ecodan FTC6, Ecodan FTC7
LJ

DHW operation error

Breakdown: the boiler is stopped Ecodan F generation

What our technician checks

  • The DHW tank water temperature thermistor (THW5 on FTC5, THW5B later), possibly disconnected
  • The flow rate of the domestic water circuit
  • The circulation pumps (primary and domestic)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.