Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Mitsubishi Electric Fault code Mitsubishi Electric
L9

Low primary circuit water flow

Breakdown: the boiler is stopped

On an Ecodan heat pump (FTC4 to FTC7, F generation), L9 means the flow switch (or, from FTC5 on, the flow sensor) has detected too low a flow in the heat pump's primary water circuit: leak, blocked strainer, circulation pump or the flow switch itself. It is a fault that does not clear by itself: our technician clears the code (reset) once the cause has been found.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show L9?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code L9

The meaning depends on the boiler: find yours below.

L9

Low primary circuit flow rate detected by flow switch (flow switches 1, 2, 3)

Breakdown: the boiler is stopped Ecodan FTC4
L9

Low primary circuit flow rate detected by flow sensor or flow switch (flow switches 1, 2, 3)

Breakdown: the boiler is stopped Ecodan FTC5, Ecodan FTC6, Ecodan FTC7
L9

Low primary circuit flow rate detected by flow sensor or flow switch (flow switches 2, 3)

Breakdown: the boiler is stopped Ecodan F generation

What our technician checks

  • Water leaks in the circuit
  • The strainer, and the magnetic filter on FTC7 and F generation
  • The water circulation pump
  • The flow switch (or flow sensor), replaced if it does not work

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.