Multiroom bridge communication failure
Breakdown: the boiler is stopped
On an Ecodan F generation heat pump with multiroom control, the bridge has lost communication with a multiroom controller device, a thermostatic radiator valve (TRV) or a room thermostat: flat battery in the device, pairing with the bridge lost, or wireless link failing. It is a fault, not normal operation; on every Ecodan, J1 and J2 can also mean a wireless remote controller that no longer talks to its receiver (codes J1 to J8).
What you can do
- Write down the code shown and the heat pump model (on the rating plate).
- Check the batteries of the thermostatic radiator valves and wireless room thermostats of the multiroom control, and replace any that are flat.
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show J1, J2?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code J1, J2
The meaning depends on the boiler: find yours below.
Communication failure between bridge and multiroom controller device (TRV, room thermostat)
What our technician checks
- The battery of the multiroom device (TRV, room thermostat)
- The pairing between the bridge and the device
- The wireless communication, tested as the multiroom controller system manual describes
- If the code comes from the wireless remote controller (J1 to J8): its battery and its pairing with the wireless receiver