Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Mitsubishi Electric Fault code Mitsubishi Electric
FL

R32 refrigerant leak detected

Breakdown: the boiler is stopped

On an Ecodan F generation heat pump, the refrigerant leak sensor has detected R32, or the sensor is not connected to the heat pump. R32 is flammable and may have no smell: the code stays on, and the heat pump may only be reset once our technician has confirmed there is no leak.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Switch the heat pump off, air the room well and keep any naked flame away, even if you smell nothing.
  3. Do not switch it back on or reset it yourself, neither on the display nor at the circuit breaker: our technician must first check that there is no leak. Call us.

Does your boiler show FL?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code FL

The meaning depends on the boiler: find yours below.

FL

R32 leak detection

Breakdown: the boiler is stopped Ecodan F generation

What our technician checks

  • No R32 refrigerant leak, confirmed before any restart
  • Leak search without any ignition source, with a detector suited to R32
  • The connection of the refrigerant leakage sensor to input IN2 (TBI.1 5-6)
  • The restart: all indoor and outdoor unit circuit breakers switched off and on, only after this check

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.