Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Elco Fault code Elco
350

Buffer tank address error

Breakdown: the boiler is stopped

The controller reports an address error for the buffer tank: this is a mistake in the installation settings. On a Trigon XXL, a Thision S Plus or a Trigon S Plus this code is one of the lockouts: the boiler stops and the cause must be removed before it is reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 350?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code 350

The meaning depends on the boiler: find yours below.

350

Puffer address sensor

Breakdown: the boiler is stopped Trigon XXL
350

Buffer storage address fault

Breakdown: the boiler is stopped Thision S Plus, Trigon S Plus

What our technician checks

  • The LPB device and segment addresses of the interconnected controllers (lines 6600 and 6601)
  • The software diagnostic code and the fault history (lines 6705 and 6800 onwards)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.