Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Elco Fault code Elco
131

Burner fault, no cause given

Breakdown: the boiler is stopped

The controller reports a burner fault, without giving the cause. The boiler goes into safety lockout and the cause must be removed before it is reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 131?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code 131

The meaning depends on the boiler: find yours below.

131

Burner fault

Breakdown: the boiler is stopped Thision S Plus, Trigon S Plus, Trigon XXL

What our technician checks

  • The burner safety devices: flow sensor, water flow monitor, minimum gas pressure switch and ionisation electrode (Trigon XXL)
  • The ionisation current, measured with a multimeter (µA) between the electrode and its connection
  • The ignition electrode (wear, damage), replaced if needed (Thision S Plus, Trigon S Plus)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.