Pressure too high in the refrigerant circuit
Breakdown: the boiler is stopped
The refrigerant pressure has risen too high and the high pressure switch (HPS) has cut out the compressor; E3-24 reports a fault of the high pressure sensor itself (of the high pressure switch on the Altherma 3 H MT). It is a safety of the refrigerant circuit: the heat pump stops and only our technician can look for the cause, often on the water side (air, valves, filter, flow). On the Altherma HT (EKHBRD), code E3 can also come from the water pipe thermal protection (Q2L).
What you can do
- Write down the code shown and the heat pump model (on the rating plate).
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show E3?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code E3
The small number shown beside the code tells which.
Abnormal high pressure
High pressure error (S1PH) / Thermal cut-out error (Q2L)
OU: Actuation of high pressure switch (HPS)
High pressure sensor abnormality
What our technician checks
- The water circuit and the tank: filled, free of air, air purge open
- The water flow: all valves in the circuit open, water filter not blocked
- The refrigerant stop valves, all open
- The unit's operating range (technical specifications)
- The wiring connections on the outdoor and indoor units
- The high pressure sensor or switch (E3-24)
- Altherma HT: the Q2L thermal cut-out, to be reset
- The detailed procedure for this code in the Daikin service manual