Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
730

Screed drying: not enough power

Breakdown: the boiler is stopped

On a Logatherm WPL heat pump (HMC20 control), the screed drying programme could not reach a flow temperature step within the set time. Drying carries on, but the fault stays on (red light) and our technician needs to check the power required.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Reset the heat pump once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 730?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 730

The meaning depends on the boiler: find yours below.

730

Screed drying output

Breakdown: the boiler is stopped HMC20

What our technician checks

  • The power required during screed drying

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.