Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
703

Frost protection: flow below 5 °C

Breakdown: the boiler is stopped

On a Logatherm WPL heat pump (HMC20 control), the flow temperature dropped below 5 °C while the heat pump was running, and the control detected a frost risk. The heat pump goes into a locked fault (red light): the fault does not clear by itself and needs our technician.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Never shut off the heat pump's heating circuit: its frost protection depends on it.
  3. Reset the heat pump once only.
  4. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 703?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 703

The meaning depends on the boiler: find yours below.

703

Frost protection

Breakdown: the boiler is stopped HMC20

What our technician checks

  • The heat pump's output
  • The defrost valve
  • The heating system

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.