Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
704

Refrigerant circuit temperature too high

Blocking: it retries by itself

On a Logatherm WPL heat pump (HMC20 control), the maximum temperature in the refrigerant circuit was exceeded; the display may call it a flue gas fault, but this is the hot gas of that circuit, not flue gas. The heat pump stops and restarts by itself after the waiting time shown (“Reset in hh:mm”).

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show 704?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 704

The meaning depends on the boiler: find yours below.

704

Hot gas fault

Blocking: it retries by itself HMC20

What our technician checks

  • The refrigerant charge
  • Evaporation
  • Superheat, flow and return
  • The WQ-min

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.