Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
715

High pressure: stop and automatic restart

Blocking: it retries by itself

On a Logatherm WPL heat pump (HMC20 control), the high pressure switch of the refrigerant circuit has tripped several times and the heat pump stops, for example when the domestic hot water cannot reach the set temperature. It restarts by itself after a short while (light flashing red and green); for hot water, the control tries again after two hours with a setpoint lowered by 1 °C.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show 715?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 715

The meaning depends on the boiler: find yours below.

715

High-pressure shutdown

Blocking: it retries by itself HMC20

What our technician checks

  • The HW flow rate
  • The differential valve
  • Temperature and condensation

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.