Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
6243

High flow and return temperature difference

Blocking: it retries by itself

On a Logatherm WLW176i or WLW186i heat pump (BC400 control), the temperature difference between the heat pump's flow and return (sensors TC3 and TC0) is too high, because too little water flows in the primary circuit. This is a warning, not an alarm: our technician has to clean the particle filter and check that all valves are open.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show 6243?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 6243

The meaning depends on the boiler: find yours below.

6243

High temperature difference between the heat pump flow and return temperature sensors (TC3-TC0)

Blocking: it retries by itself BC400

What our technician checks

  • The particle filter, inspected and cleaned
  • The circuit valves, all open

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.