1010
No communication with the controller (EMS bus)
Information: nothing to do
The boiler no longer receives any communication over the EMS bus, the link to the heating controller and the connected modules. The cause: a wiring error, the bus cable or a faulty device connected to the bus.
What you can do
- Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
- Does the code stay on or come back? Do not take anything apart: call us.
Nothing to do
This message belongs to the boiler's normal operation.
Call usChoose a real expert
Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.
The variants of code 1010
The small number shown beside the code tells which.
1010
No communication via the EMS BUS connection
Information: nothing to do
GB172i.2, GB182i.2, GB192i.2, GB272
The boilers that show this code
What our technician checks
- The EMS bus wiring, then switching the controller off and on again
- The bus cable, repaired or replaced
- The faulty device connected to the bus, replaced