Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
5485

Too little flow to the heat pump

Blocking: it retries by itself

On a Logatherm WLW176i or WLW186i heat pump (BC400 control), the water of the primary circuit flows too little to the heat pump. Our technician has to inspect and clean the particle filter, and check and vent the primary circulation pump.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show 5485?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 5485

The meaning depends on the boiler: find yours below.

5485

Circulation to the heat pump too low

Blocking: it retries by itself BC400

What our technician checks

  • The particle filter, inspected and cleaned
  • The primary circulation pump PC0, checked and vented

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.