Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
5111

TC3 sensor signal out of range

Breakdown: the boiler is stopped

On a Logatherm WLW176i or WLW186i heat pump (BC400 control), the signal of the condenser temperature sensor TC3 is outside the permitted range; the cause to look for is the bus cable, wrongly connected or faulty. This is an alarm: our technician has to find the cause.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show 5111?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 5111

The meaning depends on the boiler: find yours below.

5111

The signal of temperature sensor TC3 on the condenser is outside the permitted range

Breakdown: the boiler is stopped BC400

What our technician checks

  • The bus cable connection, then switching the controller off and on again
  • The bus cable, repaired or replaced

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.