Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
2Y

Heating pump problem

Breakdown: the boiler is stopped

The heating pump is stuck, running dry, not building up pressure or not sending a signal back to the boiler. Depending on the case, this is just a message, a temporary stop or a lockout.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 2Y?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 2Y

The small number shown beside the code tells which.

2Y
281

The pump is blocked or running dry

Blocking: it retries by itself GB162, GB172, GB172i
2Y
282

No pump control signal

Breakdown: the boiler is stopped GB162, GB172, GB172i

The boilers that show this code

What our technician checks

  • The water pressure, and venting of the system and the appliance
  • Isolation valves open and sufficient water flow
  • The pump: wiring, start-up; replaced if necessary
  • GB162: the pressure switch

The same fault on other boilers

Recent boilers show alone the number older ones show beside the code.

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.