Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Buderus Fault code Buderus
282

No feedback signal from the pump

Information: nothing to do

The heating pump (circulator) is not sending the boiler information about its speed, or is not receiving a control signal. Depending on the model, this is just a message or a fault that locks out the boiler.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Nothing to do

This message belongs to the boiler's normal operation.

Call us
Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 282

The small number shown beside the code tells which.

282

No speed feedback from the pump

Information: nothing to do GB192i

The boilers that show this code

What our technician checks

  • The wiring and operation of the circulator; replaced if necessary

The same fault on other boilers

Recent boilers show alone the number older ones show beside the code.

2Y

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.